![]() ![]() ![]() Other people attempt to “scare the dog” with the correction and turn it up too high for them. If the correction is set too low, the dog will think that it is no big deal, and potentially wander out into the street. Some people choose to set the correction level very low, because they fear about hurting the dog. If you are uncertain about which correction level to use, guess high for strong-willed dogs and guess low for mild-mannered dogs. You are basically making an educated guess until the dog has received his first correction and you see his reaction. The correction level that is needed for each dog is different, because each dog is different. Medium-sized dogs can have a medium setting and large, strong-willed dog can be on a high setting. Setting the Level of Correction How to increase width of the signalįor small or sensitive dogs, you should start with the correction level on the lowest setting. It is important that you as the owner stay calm and confident, so that the dog will not feel nervous if you do. Since the dog was already taught to turn and retreat when they hear the beep, adding the correction will further reinforce this association.Īfter the first correction, you can adjust the strength of the correction so that it is strong enough to capture the dog’s attention, but not so strong that it is overwhelming to the dog. The lessons of the first step are reinforced, that the dog must turn and retreat whenever they hear the warning beep.Īdding the correction will help solidify the boundary rules that were taught in Step One. This shows the dog that the consequence for ignoring the beep is a static shock. Now, the correction is added to our training. Step 2: Introducing the Correction Setting the level of correction A victory lap is done so that your dog knows that the yard is safe. ![]() Just do a quick lap around the safe zone away from the training flags. Start and end each session with a victory lap! If you run, your dog will run too. Repeat this process during every training session using different areas of the yard at least 3 times a day for the first 2 days. When the dog goes back over into the safe zone, reward him with praise and a treat. Be sure to install a sense of urgency in this initial session. Next, give the “no” command and lead the dog away from the flags, back into the safety zone. When he does, he will hear the beep on the collar. Don’t attach a leash to the receiver collar because you don’t want to put any pressure on the contact points of your dog’s neck.Īllow your dog to approach the flags, but never encourage him to do so. In step one, you are taking your dog out on a long leash that is attached to your dog’s regular collar. Small bits of roast beef, chicken or hot dogs can seriously aid in the training process. Your dog will be more likely to stay interested and eager to train. Playing with your dog starts things off on a positive note. ![]() Playtimeīegin each session with playtime. Should you ever see red spots on your dog’s neck, remove the collar immediately, and discontinue use until the sores have healed. Leaving a collar on for too long can cause a condition called pressure necrosis, which are red sore spots on the dog’s neck. *As a side note, be sure to not leave your dog’s containment collar on for more than 12 hours a day. If you can freely spin the collar around the dog’s neck, it is too loose and your dog will not feel the correction. You should only be able to get one finger between the probes on the collar and your dog’s neck. The collar should fit perhaps more snugly than you think. The receiver box should be at the front of the dog’s neck, underneath his head. Fitting the CollarĪn electric dog fence receiver collar should be worn high up on the dog’s neck, ideally right below the ears. With the eXtreme Dog Fence, you can do this by putting it in beep only mode. Does the gauge of dog fence wire really matter?įor Step One, it is important to disable the stimulation.How Can Our Electric Dog Fence Help You?.Extreme Dog Fence Transmitter and Collar Only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |